Installation Notes – CR10 Mini – 2nd Z-Axis

There are two reasons I installed a second z-axis; one reason was to balance the weight of a direct drive extruder I planned to install. The other reason was to balance the weight of the x-axis in general. I noticed in December that the axis was lower on the right side of the machine byContinue reading “Installation Notes – CR10 Mini – 2nd Z-Axis”

Installation Notes – CR10 Mini – Direct Drive Extruder

I installed a Micro Swiss Direct Drive Extruder a few days ago. Since I watched a video before buying the extruder, I knew the extruder motor would be stationed on the x-axis. I decided then that a second lead screw was needed and installed it the day before installing the extruder. There will be aContinue reading “Installation Notes – CR10 Mini – Direct Drive Extruder”