What to do with empty filament spools? That question has been asked for some years now. I have seen it asked more frequently in Facebook printer groups during the past few months. The answer has not changed much over the years. Some filament providers have changed from using plastic to cardboard, but there are plentyContinue reading “Empty Filament Spool Ideas”
Upon seeing an announcement about colorFabb’s LW-PLA, my first thought was cushions. The filament was on back order at the time and I waited a few months for it to arrive. I waited again before I tried printing with the filament as I learned a direct drive extruder was best. Finally, in February I wasContinue reading “Is A Chair Cushion Possible With colorFabb LW-PLA?”
Just in case you missed news about Cura’s triangles infill, the photos above and below are examples printed with Push Plastic’s Translucent Green. Both examples were printed with one perimeter, 30 % infill, and 0.2 layer height. I have tried using Cura’s gyroid infill without perimeters, hoping to get results similar to Stefan of CNCContinue reading “Cura’s Triangles Infill”
3DPrint.com published an article a few days ago concerning research on using PLA filament for objects in the “sterile surgical field.” I can barely contain my excitement!
I thought of designing this Umbrella Stand Divider while trying to think of an attractive and convenient place to store my compact umbrella until it dried. There is enough space for putting a sopping wet purse or bag should that become necessary as well. I really appreciated having this during the last summer and fallContinue reading “Umbrella Stand”